faucet design. Wednesday , February 21st , 2018 - 17:56:16 PM
If a cat touches your touch sensitive faucet, it will, most likely, be too long a contact for the faucet to turn on. A canary landing on the faucet won′t activate it either. Well, how likely is a situation when your kitten would be sitting there and touching the faucet with its paw? Situations of this kind are extremely unlikely to happen. But even if they do once in a while, a good faucet has a built-in system that turns the water off automatically after a certain period of inactivity. It is usually configured somewhere between 3 and 5 minutes. So even if the faucet gets turned on by some unusual circumstance, the loss from that will be rather insignificant.
To disassemble unscrew the setscrew and pull off handle. Tighten the plastic adjusting ring inside the cap by turning it with a special flat adjusting tool-or fit tow screwdrivers into the slots and cross their blades to turn the ring. If your ball-style faucet with this type of cap is leaking from the spout, first try tightening the cap with channel pliers. Still leaking? Disassemble and replace worn/broken parts. Often you need to lift out the ball and replace the rubber seats and springs on both sides of the valve. If the faucet leaks around the spout, replace worn o-rings. Replace rotating ball only if clearly worn.
It can be cheap because it is very basic but still good-looking and reliable. In this case, there is no problem. But beware of too low-priced faucets that offer you a ton of advanced features like pull-out spray wand, fingertip operation of the handle or even touch sensitivity. If your faith is strong enough, such can serve you well for some time, but I fear to make a guess how long or short it can be.