faucet design. Wednesday , February 21st , 2018 - 17:39:41 PM
To disassemble unscrew the bonnet from the faucet, using slip-joint pliers. Remove the valve stem, keeping in mind this has reverse threads, so unscrew it by turning it clockwise. Older compression faucets may have corroded handles that can be difficult to remove. Most hardware stores and rental centers have a specialty tool called a Handle Puller which makes the job easier.
Faucets begin to drip when washers, o-rings, or seals inside the faucet are dirty with sediment, covered with mineral deposits, or just worn-out. Fixing a faucet is fairly easy, but varies depending on the type of faucet you have (see below for specific description and instructions). Once you know your faucet design, you can properly disassemble the faucet, locate the source of the leak, and then replace the worn parts or clean dirty parts.
But there are faucets on which the spots will be much less visible and easier to clean. You only have to find a faucet with a surface designed especially for the clean look. If you do an online research, you can find references to such a feature in the descriptions that are available on the manufacturers′ or retailers′ sites. If you find a site that does not offer you a detailed description, it is a good reason for you to leave that site. There are a lot of customer oriented sites on the Internet that supply even more information about the items they feature than you can possibly get at your offline store.