faucet design. Wednesday , February 21st , 2018 - 19:10:59 PM
Once you have the faucet out, replace all rubber washers and o-rings. When replacing washers, check the condition of the metal valve seats inside the faucet body. If the valve seats feel rough, they should be replaced or resurfaced.
To disassemble unscrew the setscrew and pull off handle. Though these faucets are washerless, they do have inlet and outlet seals that may leak, or sediment may build up inside the inlets and cause leaks. After removing the escutcheon cap, lift out the cylinder and clean the neoprene seals and cylinder openings. Be sure the faucet is in the "open" position when replacing seals.
To disassemble unscrew the setscrew and pull off handle. Tighten the plastic adjusting ring inside the cap by turning it with a special flat adjusting tool-or fit tow screwdrivers into the slots and cross their blades to turn the ring. If your ball-style faucet with this type of cap is leaking from the spout, first try tightening the cap with channel pliers. Still leaking? Disassemble and replace worn/broken parts. Often you need to lift out the ball and replace the rubber seats and springs on both sides of the valve. If the faucet leaks around the spout, replace worn o-rings. Replace rotating ball only if clearly worn.