faucet design. Thursday , February 22nd , 2018 - 16:16:22 PM
Once you have the faucet out, replace all rubber washers and o-rings. When replacing washers, check the condition of the metal valve seats inside the faucet body. If the valve seats feel rough, they should be replaced or resurfaced.
It is quite obvious that the touch feature is powered by electricity. Sometimes people ask whether the faucets need to be connected to the mains. They think it might be dangerous. Others mistrust the very idea of electricity and water being together in a faucet. In fact, the touch sensitive faucets are powered by a set of four or six 1.5 V batteries. The voltage reached by such a pack does not exceed 9 volts, which is considered safe voltage even by the strictest regulations. The electricity, however weak, never comes in contact with water. In a typical touch sensitive faucet, water runs inside pipes made from non-conductive materials. So there is no threat whatsoever that could be attributed to the use of electricity in touch sensitive faucets.
To disassemble unscrew the setscrew and pull off handle. Though these faucets are washerless, they do have inlet and outlet seals that may leak, or sediment may build up inside the inlets and cause leaks. After removing the escutcheon cap, lift out the cylinder and clean the neoprene seals and cylinder openings. Be sure the faucet is in the "open" position when replacing seals.