faucet design. Thursday , February 22nd , 2018 - 18:14:27 PM
Once you have the faucet out, replace all rubber washers and o-rings. When replacing washers, check the condition of the metal valve seats inside the faucet body. If the valve seats feel rough, they should be replaced or resurfaced.
If you have never held a wrench in your hand, you probably do need a plumber to help you with the installation. But if you know how to connect an end of a pipe to the supply, you can do all the things on your own. Every faucet that is worth your attention will come with detailed instructions. But the process is highly intuitive, too. Basically, the lower part of the faucet comes through the installation hole on your sink or counter-top, hot and cold water pipes connected and the faucet fastened with nuts from beneath.
One of the first things to know before shopping for a faucet is your hole configuration. Most sinks come with holes drilled to receive the faucet and sometimes accessories such as a sprayer, soap dispenser, hot beverage or filtered water faucet. One hole sinks are for single-control faucets, three hole are for single-control faucets with a sprayer and/or accessories and four holes are for single-control or two-handle sinks with various accessories. If you have an under-mount or apron front sink the holes are drilled into the countertop behind the sink.