felicia. faucet design. February 22nd , 2018.
If you have never held a wrench in your hand, you probably do need a plumber to help you with the installation. But if you know how to connect an end of a pipe to the supply, you can do all the things on your own. Every faucet that is worth your attention will come with detailed instructions. But the process is highly intuitive, too. Basically, the lower part of the faucet comes through the installation hole on your sink or counter-top, hot and cold water pipes connected and the faucet fastened with nuts from beneath.
Faucets begin to drip when washers, o-rings, or seals inside the faucet are dirty with sediment, covered with mineral deposits, or just worn-out. Fixing a faucet is fairly easy, but varies depending on the type of faucet you have (see below for specific description and instructions). Once you know your faucet design, you can properly disassemble the faucet, locate the source of the leak, and then replace the worn parts or clean dirty parts.
To disassemble unscrew and pull off handle. To release the cartridge, use a pair of pliers to pull the retainer clip straight out. Pull out the cartridge and replace the o-rings and seals to fix leaks. You may need to replace the entire cartridge-it is an easy repair that will fix the majority of cartridge faucet leaks. Faucet cartridge come in many styles, so bring the old cartridge to the store. Be sure to insert the new cartridge so it is aligned in the same way as the old cartridge. If the hot and cold are reversed, take the faucet apart and rotate 180 degrees.
If a cat touches your touch sensitive faucet, it will, most likely, be too long a contact for the faucet to turn on. A canary landing on the faucet won′t activate it either. Well, how likely is a situation when your kitten would be sitting there and touching the faucet with its paw? Situations of this kind are extremely unlikely to happen. But even if they do once in a while, a good faucet has a built-in system that turns the water off automatically after a certain period of inactivity. It is usually configured somewhere between 3 and 5 minutes. So even if the faucet gets turned on by some unusual circumstance, the loss from that will be rather insignificant.