faucet design. Friday , February 23rd , 2018 - 15:32:01 PM
Once you have the faucet out, replace all rubber washers and o-rings. When replacing washers, check the condition of the metal valve seats inside the faucet body. If the valve seats feel rough, they should be replaced or resurfaced.
It is quite obvious that the touch feature is powered by electricity. Sometimes people ask whether the faucets need to be connected to the mains. They think it might be dangerous. Others mistrust the very idea of electricity and water being together in a faucet. In fact, the touch sensitive faucets are powered by a set of four or six 1.5 V batteries. The voltage reached by such a pack does not exceed 9 volts, which is considered safe voltage even by the strictest regulations. The electricity, however weak, never comes in contact with water. In a typical touch sensitive faucet, water runs inside pipes made from non-conductive materials. So there is no threat whatsoever that could be attributed to the use of electricity in touch sensitive faucets.
To disassemble unscrew and pull off handle. To release the cartridge, use a pair of pliers to pull the retainer clip straight out. Pull out the cartridge and replace the o-rings and seals to fix leaks. You may need to replace the entire cartridge-it is an easy repair that will fix the majority of cartridge faucet leaks. Faucet cartridge come in many styles, so bring the old cartridge to the store. Be sure to insert the new cartridge so it is aligned in the same way as the old cartridge. If the hot and cold are reversed, take the faucet apart and rotate 180 degrees.