faucet design. Friday , February 23rd , 2018 - 15:37:15 PM
To disassemble unscrew the bonnet from the faucet, using slip-joint pliers. Remove the valve stem, keeping in mind this has reverse threads, so unscrew it by turning it clockwise. Older compression faucets may have corroded handles that can be difficult to remove. Most hardware stores and rental centers have a specialty tool called a Handle Puller which makes the job easier.
To disassemble unscrew and pull off handle. To release the cartridge, use a pair of pliers to pull the retainer clip straight out. Pull out the cartridge and replace the o-rings and seals to fix leaks. You may need to replace the entire cartridge-it is an easy repair that will fix the majority of cartridge faucet leaks. Faucet cartridge come in many styles, so bring the old cartridge to the store. Be sure to insert the new cartridge so it is aligned in the same way as the old cartridge. If the hot and cold are reversed, take the faucet apart and rotate 180 degrees.
Faucets begin to drip when washers, o-rings, or seals inside the faucet are dirty with sediment, covered with mineral deposits, or just worn-out. Fixing a faucet is fairly easy, but varies depending on the type of faucet you have (see below for specific description and instructions). Once you know your faucet design, you can properly disassemble the faucet, locate the source of the leak, and then replace the worn parts or clean dirty parts.