faucet design. Friday , February 23rd , 2018 - 15:48:26 PM
Faucets begin to drip when washers, o-rings, or seals inside the faucet are dirty with sediment, covered with mineral deposits, or just worn-out. Fixing a faucet is fairly easy, but varies depending on the type of faucet you have (see below for specific description and instructions). Once you know your faucet design, you can properly disassemble the faucet, locate the source of the leak, and then replace the worn parts or clean dirty parts.
The faucets with detachable spray wands have become extremely popular during the last decades. But there is always some doubt whether the pull-out wand will have a snug enough fit into its dock. If the wand does not sit very well, the faucet loses a lot. It can be beautifully designed, but if the spray head does not sit where it should, the whole faucet will look cheap and inferior. That is why the leading manufacturers of kitchen faucets have done their best to secure the wand firmly in its place.
One of the first things to know before shopping for a faucet is your hole configuration. Most sinks come with holes drilled to receive the faucet and sometimes accessories such as a sprayer, soap dispenser, hot beverage or filtered water faucet. One hole sinks are for single-control faucets, three hole are for single-control faucets with a sprayer and/or accessories and four holes are for single-control or two-handle sinks with various accessories. If you have an under-mount or apron front sink the holes are drilled into the countertop behind the sink.