andreas faucet design, 2018-02-23 16:50:49. Faucets begin to drip when washers, o-rings, or seals inside the faucet are dirty with sediment, covered with mineral deposits, or just worn-out. Fixing a faucet is fairly easy, but varies depending on the type of faucet you have (see below for specific description and instructions). Once you know your faucet design, you can properly disassemble the faucet, locate the source of the leak, and then replace the worn parts or clean dirty parts.
andreas faucet design, 2018-02-20 18:07:57. To disassemble unscrew the bonnet from the faucet, using slip-joint pliers. Remove the valve stem, keeping in mind this has reverse threads, so unscrew it by turning it clockwise. Older compression faucets may have corroded handles that can be difficult to remove. Most hardware stores and rental centers have a specialty tool called a Handle Puller which makes the job easier.
felicia faucet design, 2018-02-20 18:14:56. If you wash a lot of large pots, fill vases often or have a big roomy sink a high arc faucet is probably for you. High-arc, also known as gooseneck or high neck faucets, give you more room to work. Today′s high arc kitchen faucets often have beautiful flowing curves and tapered handles and could easily be the focal point of a kitchen. These faucets are best used in deep sinks, they will cause splashing if the sink is shallow. Most bar sink faucets are of the high arc type to allow as much room as possible for washing produce.
felicia faucet design, 2018-02-20 18:07:27. Faucet manufacturers make several types of replacement kits for ball-type faucets; some kits have only the springs and neoprene valve seats, while better kits also have the cam and cam washer.
benjamin faucet design, 2018-02-20 18:07:02. The faucets with detachable spray wands have become extremely popular during the last decades. But there is always some doubt whether the pull-out wand will have a snug enough fit into its dock. If the wand does not sit very well, the faucet loses a lot. It can be beautifully designed, but if the spray head does not sit where it should, the whole faucet will look cheap and inferior. That is why the leading manufacturers of kitchen faucets have done their best to secure the wand firmly in its place.
celindion faucet design, 2018-02-20 18:05:52. First - Determine Faucet Design: There are four basic faucet designs: ball-style, cartridge, disc, and compression. Sometimes a faucet type can be determined by the outer appearance, but often the faucet must be taken apart to identify what kind of faucet it is. The four faucet designs come under two categories: washer and washer-less.
benjamin faucet design, 2018-02-20 18:05:29. To disassemble unscrew and pull off handle. To release the cartridge, use a pair of pliers to pull the retainer clip straight out. Pull out the cartridge and replace the o-rings and seals to fix leaks. You may need to replace the entire cartridge-it is an easy repair that will fix the majority of cartridge faucet leaks. Faucet cartridge come in many styles, so bring the old cartridge to the store. Be sure to insert the new cartridge so it is aligned in the same way as the old cartridge. If the hot and cold are reversed, take the faucet apart and rotate 180 degrees.
derbyan faucet design, 2018-02-20 18:06:35. Important: After making repairs to a disc faucet, it is imperative the handle in the ON position, then open the shutoff valves slowly. The ceramic discs can be cracked by the sudden release of air from the faucet. Once the water is running steadily, it is safe to close the faucet.