andreas faucet design, 2018-02-23 16:50:49. One of the first things to know before shopping for a faucet is your hole configuration. Most sinks come with holes drilled to receive the faucet and sometimes accessories such as a sprayer, soap dispenser, hot beverage or filtered water faucet. One hole sinks are for single-control faucets, three hole are for single-control faucets with a sprayer and/or accessories and four holes are for single-control or two-handle sinks with various accessories. If you have an under-mount or apron front sink the holes are drilled into the countertop behind the sink.
celindion faucet design, 2018-02-23 16:39:02. Single handle faucets still make up more than 80% of faucet sales and are popular with builders. These faucets are basic and have a single handle that controls temperature and flow. These are available with a side spray which is much less expensive than the pull-out spray faucets. They also allow you to have a spray with a vintage-look faucet.
benjamin faucet design, 2018-02-23 16:39:36. For modern faucets, the truth is quite opposite though. The touch function is reliable and under normal conditions always works as expected. These faucets cannot be activated by pets, and they are helpful for families with children.
andreas faucet design, 2018-02-23 16:38:13. It is quite obvious that the touch feature is powered by electricity. Sometimes people ask whether the faucets need to be connected to the mains. They think it might be dangerous. Others mistrust the very idea of electricity and water being together in a faucet. In fact, the touch sensitive faucets are powered by a set of four or six 1.5 V batteries. The voltage reached by such a pack does not exceed 9 volts, which is considered safe voltage even by the strictest regulations. The electricity, however weak, never comes in contact with water. In a typical touch sensitive faucet, water runs inside pipes made from non-conductive materials. So there is no threat whatsoever that could be attributed to the use of electricity in touch sensitive faucets.
felicia faucet design, 2018-02-23 16:41:06. Once you have the faucet out, replace all rubber washers and o-rings. When replacing washers, check the condition of the metal valve seats inside the faucet body. If the valve seats feel rough, they should be replaced or resurfaced.
derbyan faucet design, 2018-02-23 16:39:18. Apart of that, you may want to know how long a distance the wand retracts from. On some faucets, the wand will come back to the dock from any point where you release it. Others will need to be brought close to the dock to activate the forces that pull it in.
felicia faucet design, 2018-02-23 16:37:45. To disassemble unscrew the bonnet from the faucet, using slip-joint pliers. Remove the valve stem, keeping in mind this has reverse threads, so unscrew it by turning it clockwise. Older compression faucets may have corroded handles that can be difficult to remove. Most hardware stores and rental centers have a specialty tool called a Handle Puller which makes the job easier.
felicia faucet design, 2018-02-23 16:48:29. A small drip from a leaky faucet might seem like a little annoyance, yet it actually can cost you hundreds of dollars a year in water down the drain and next to nothing to fix. A leaky faucet is one of the most common home plumbing problems. Faucets are relatively easy to fix-once you know how they work and what to do to fix them.