faucet design. Friday , February 23rd , 2018 - 16:38:29 PM
If you have never held a wrench in your hand, you probably do need a plumber to help you with the installation. But if you know how to connect an end of a pipe to the supply, you can do all the things on your own. Every faucet that is worth your attention will come with detailed instructions. But the process is highly intuitive, too. Basically, the lower part of the faucet comes through the installation hole on your sink or counter-top, hot and cold water pipes connected and the faucet fastened with nuts from beneath.
To disassemble unscrew the bonnet from the faucet, using slip-joint pliers. Remove the valve stem, keeping in mind this has reverse threads, so unscrew it by turning it clockwise. Older compression faucets may have corroded handles that can be difficult to remove. Most hardware stores and rental centers have a specialty tool called a Handle Puller which makes the job easier.
Some use strong magnets that do a good job to hold the wand in the dock. Others use a smart combination of weights, extremely precise docks and flexible hoses. Whatever the method used in the faucet to keep the spray wand in its place, it might be wise to consult the users′ feedback to see if there are problems with loose fit.