faucet design. Friday , February 23rd , 2018 - 16:36:10 PM
If you have never held a wrench in your hand, you probably do need a plumber to help you with the installation. But if you know how to connect an end of a pipe to the supply, you can do all the things on your own. Every faucet that is worth your attention will come with detailed instructions. But the process is highly intuitive, too. Basically, the lower part of the faucet comes through the installation hole on your sink or counter-top, hot and cold water pipes connected and the faucet fastened with nuts from beneath.
To disassemble unscrew the setscrew and pull off handle. Tighten the plastic adjusting ring inside the cap by turning it with a special flat adjusting tool-or fit tow screwdrivers into the slots and cross their blades to turn the ring. If your ball-style faucet with this type of cap is leaking from the spout, first try tightening the cap with channel pliers. Still leaking? Disassemble and replace worn/broken parts. Often you need to lift out the ball and replace the rubber seats and springs on both sides of the valve. If the faucet leaks around the spout, replace worn o-rings. Replace rotating ball only if clearly worn.
First - Determine Faucet Design: There are four basic faucet designs: ball-style, cartridge, disc, and compression. Sometimes a faucet type can be determined by the outer appearance, but often the faucet must be taken apart to identify what kind of faucet it is. The four faucet designs come under two categories: washer and washer-less.