faucet design. Friday , February 23rd , 2018 - 16:36:43 PM
One of the first things to know before shopping for a faucet is your hole configuration. Most sinks come with holes drilled to receive the faucet and sometimes accessories such as a sprayer, soap dispenser, hot beverage or filtered water faucet. One hole sinks are for single-control faucets, three hole are for single-control faucets with a sprayer and/or accessories and four holes are for single-control or two-handle sinks with various accessories. If you have an under-mount or apron front sink the holes are drilled into the countertop behind the sink.
To disassemble unscrew the setscrew and pull off handle. Tighten the plastic adjusting ring inside the cap by turning it with a special flat adjusting tool-or fit tow screwdrivers into the slots and cross their blades to turn the ring. If your ball-style faucet with this type of cap is leaking from the spout, first try tightening the cap with channel pliers. Still leaking? Disassemble and replace worn/broken parts. Often you need to lift out the ball and replace the rubber seats and springs on both sides of the valve. If the faucet leaks around the spout, replace worn o-rings. Replace rotating ball only if clearly worn.
But do these fears have substance? Haven′t the engineers and designers of the best touch sensitive kitchen faucets anticipated these situations? Do we still have to deny ourselves the liberating feeling of operation with a touch and choose a more basic faucet only because we are not sure it will live up to the expectations?