faucet design. Friday , February 23rd , 2018 - 16:45:48 PM
Faucets begin to drip when washers, o-rings, or seals inside the faucet are dirty with sediment, covered with mineral deposits, or just worn-out. Fixing a faucet is fairly easy, but varies depending on the type of faucet you have (see below for specific description and instructions). Once you know your faucet design, you can properly disassemble the faucet, locate the source of the leak, and then replace the worn parts or clean dirty parts.
To disassemble unscrew the setscrew and pull off handle. Tighten the plastic adjusting ring inside the cap by turning it with a special flat adjusting tool-or fit tow screwdrivers into the slots and cross their blades to turn the ring. If your ball-style faucet with this type of cap is leaking from the spout, first try tightening the cap with channel pliers. Still leaking? Disassemble and replace worn/broken parts. Often you need to lift out the ball and replace the rubber seats and springs on both sides of the valve. If the faucet leaks around the spout, replace worn o-rings. Replace rotating ball only if clearly worn.
Disc Faucet - a top-quality fixture, the disc faucet has a single handle and is identified by the wide cylinder by the faucet body. The cylinder contains a pair of closely fitting ceramic discs that regulate the water flow: a movable upper disc turns or lifts and lowers against a fixed lower ceramic disc. Most ceramic disc faucets don′t drip or leak because they′re made to be almost maintenance free. Dripping at the spout occurs when the neoprene seals or cylinder openings are dirty. If the faucet continues to leak after cleaning, then install a new cylinder.