faucet design. Friday , February 23rd , 2018 - 16:46:32 PM
Once you have the faucet out, replace all rubber washers and o-rings. When replacing washers, check the condition of the metal valve seats inside the faucet body. If the valve seats feel rough, they should be replaced or resurfaced.
Much is lost from the elegant look when water spots or fingerprints are too explicitly visible on the surface of the faucet. They can be really annoying when you need to keep watch and clean them many times a day. All faucets everywhere in the world will be exposed to this nuisance to a certain extent, and cleaning is the only remedy.
It is quite obvious that the touch feature is powered by electricity. Sometimes people ask whether the faucets need to be connected to the mains. They think it might be dangerous. Others mistrust the very idea of electricity and water being together in a faucet. In fact, the touch sensitive faucets are powered by a set of four or six 1.5 V batteries. The voltage reached by such a pack does not exceed 9 volts, which is considered safe voltage even by the strictest regulations. The electricity, however weak, never comes in contact with water. In a typical touch sensitive faucet, water runs inside pipes made from non-conductive materials. So there is no threat whatsoever that could be attributed to the use of electricity in touch sensitive faucets.