faucet design. Friday , February 23rd , 2018 - 16:48:16 PM
Faucets begin to drip when washers, o-rings, or seals inside the faucet are dirty with sediment, covered with mineral deposits, or just worn-out. Fixing a faucet is fairly easy, but varies depending on the type of faucet you have (see below for specific description and instructions). Once you know your faucet design, you can properly disassemble the faucet, locate the source of the leak, and then replace the worn parts or clean dirty parts.
Cartridge Faucet - this washerless faucet is identified by the narrow metal or plastic cartridge inside the faucet body; and it is available in both single and double handled cartridge designs. Cartridge faucets have a hollow cartridge insert that lifts and rotates to control the flow and temperature of water. Dripping at the spout occurs when the cartridge seals wear out. Leaks at the base are caused by worn o-rings.
It is quite obvious that the touch feature is powered by electricity. Sometimes people ask whether the faucets need to be connected to the mains. They think it might be dangerous. Others mistrust the very idea of electricity and water being together in a faucet. In fact, the touch sensitive faucets are powered by a set of four or six 1.5 V batteries. The voltage reached by such a pack does not exceed 9 volts, which is considered safe voltage even by the strictest regulations. The electricity, however weak, never comes in contact with water. In a typical touch sensitive faucet, water runs inside pipes made from non-conductive materials. So there is no threat whatsoever that could be attributed to the use of electricity in touch sensitive faucets.